Filter
Top Products
Operation - Using the Sprayer (continued)
29
C. Ensure correct spray pattern
Make sure both boom nozzles are pointed toward the ground. If they are not,
loosen the nozzle retaining nut, orient the opening of the boom nozzle to point
st raight down, then retighten the nozzle retaining nut.
IMPORTANT: Make sure broadcast nozzles are oriented to spray straight
down before you start. An incorrectly positioned broadcast nozzle may spray
chemicals on you or others.
Note: It is not unusual for the operator to be exposed to chemical drips while
adjusting the broadcast nozzle. Chemical resistant gloves should be worn.
D. En su re uniform cove rage
To ensure proper coverage, the height of the unfolded boom nozzles should be
about 23” from the ground. The sprayer must be level with the ground to get
this height.
The overall spray width is 120”, but 1/3 or 40” of the overall spray pattern must
be overlapped to get equal coverage throughout the spray area.
Use the tables in Appendix A to determine what speed to drive your vehicle for
the desired application rate
E. Begin to spray
Turn the remote switch ON to begin spraying.
8. Leaving
unattended
If the spraye r must be left unattende d at any time:
a) Disconnect power to the sprayer.
b) Relieve system pressure by depressing the gun trigger.
c) Turn off the vehicle. Set brake or block the wheels.
9. Discontinue use if
clogged or
inoperative
If the spraye r be come s clogged or inoperative during use, discontinue use
immediately.
- DO NOT attempt to service while chemicals are in the sprayer and power is
connected.
- Return to service area to review instructions for troubleshooting before
attempting to service.
Note: A reserve, clean container capable of holding at least 16 gallons (Item# 28517) or 26 gallons (Item#
28518) should be kept for use when the sprayer tank needs to be emptied temporarily for repairs. It is
advisable to purchase a reserve tank suitable for pesticide storage from Northern Tool and Equipment
for use in these circumstances. The container should be properly labeled as to its contents if it is used.
Nozzle retaining nut
Boom nozzle
1
/3
1
/3
1
/3
2
3
”