Filter
Top Products
Assembly (continued)
16
1. Preparatory safety Preparatory safety steps:
• ALWAYS use eye protection
• NEVER smoke or work near sparks or other sources of ignition.
• NEVER touch both battery terminals at the same time or with any non-
insulated tools.
• If battery acid contacts skin or clothing, flush immediately wit h water and
neutralize with baking soda.
2. Connect remote
switch to battery
Connect the sprayer’s remote switch to the vehicle battery using the
following procedure:
a) Disconnect the vehicle battery ground wire.
b) Connect the remote switch’s red battery clamp to the positive(+) terminal
of the battery.
c) Connect the remote switch’s black battery clamp to the negative(-) terminal
of the battery.
d) Reconnect the vehicle battery ground wire.
WARNING: Always connect in this sequence to avoid possible shock.
3. Connect remote
switch to pump
power cord
Connect the remote switch to the pump power cord:
Note: Make sure the power switch is in the OFF position on the remote switch.
4. Ve rify conne ction
Ve rify a com plete conne ction h as been made by checking with a DC voltmeter,
or by briefly turning the remote switch to the ON position and listening for pump
activation.
5. Attach remote switch
to vehicle
Using supplied velcro pad, affix remote switch to vehicle in a position that is
easily reached from the driver’s seat.
6. Disconnect after use
AFTER EACH USE, disconnect power to the sprayer by disconnecting the
sprayer’s pump cord from the remote switch – the remote switch may remain
connected to the battery.
NOTE: It is important to disconnect power to the sprayer when not in use for
safety reasons. ALWAYS verify that the power has been disconnected or the
remote switch is in the OFF position before adding chemicals or servicing.
Pump power cord
Remote switch