Filter
Top Products
Operation - Using the Sprayer (continued)
27
Step Three: Operate the sprayer.
WARNING
ALWAYS wear personal protective equipment as directed on the
chemical label when spraying.
Long pants and sleeves, chemical-resistant gloves, and eye protection are
st rongly recommended. Additional protective gear may be required
depending on the particular pesticide.
1. Review safety
information
Re view the “O peration – Important Safe ty Information” related to Chemical
Application Safety and ATV Vehicle Handling Safety provided in this manual.
2. Wear personal
protective
equipment
Wear personal protective equipment as directed on the chemical label.
3. Close boom valves Close boom valves to prevent accidental spray release.
4. Turn on power Turn on the power to the sprayer.
1. Verify the remote switch is connected to the pump power cord.
2. Turn the remote switch to the “ON” position.
Note: The pump will start automatically when power is turned on. The pump
will cycle on and off as needed to retain pressure in the hose.
5. Begin agitation if
needed
Some formulations of liquid pesticides do not remain in solution and should
be agitated to maintain a uniform mix.
An optional agitator (Item #28520) accessory is available for use with this
sprayer and should be used when spraying pesticides classified as “flowable”
(“F” or “L”), “wettable powder” (“WP” or “W”), “emulsion” (“EC” or “E”),
“microencapsulated” (“M”), or water dispersible granules (“WDG” or “DF”).
(See pesticide label to determine its classification.)
Contact NorthStar Customer Service at 1-800-270-0810 for any questions
about the appropriate use of the sprayer and/or optional accessories.
Closed boom
valves