Filter
Top Products
SERVICE AND ADJUSTMENT
19
F-051302L
HOW TO ADJUST THE CARBURETOR
A dirty air cleaner will cause the engine to
run improperly or to smoke excessively. Be-
fore adjusting the carburetor, make sure the
air cleaner is clean. Never make unneces-
sary adjustments to the carburetor. The car-
buretor was set at the factory to operate
efficiently under most applications. However,
if adjustments are required, we recommend
you contact an Authorized Service Center. If
you feel that you are competent to make car-
buretor adjustment proceed as follows.
1. Lower the wheels to the transport posi-
tion.
2. Locate the idle speed adjustment
screw (see Figure 15). Turn the idle ad-
justment screw 1/4 turn counterclock-
wise (to the left).
3. Start the engine and release the throttle
control.
4. Tilt the cultivator back on the wheels or
stake so that the tines are off the ground.
In correct adjustment, the tines will not
rotate when the throttle is released. If the
tines turn, repeat step 2.
WARNING: The engine gover-
nor is set at the factory. Do not
change the governor setting.
Over speeding the engine above the fac-
tory setting can be dangerous. If you
think the engine governor needs an ad-
justment, contact an Authorized Service
Center.
Figure 15
Carburetor
Idle Speed
Adjustment Screw
Carburetor is located between the fuel
tank/air filter and the engine.
Engine Shown With Fuel Tank Removed