Filter
Top Products
PAGE 30 — MQ PS4030 SAW • OPERATION MANUAL — REV. #0 (02/29/08)
MQ PS4030 SAW — WATER DELIVERY SYSTEMS
Water Delivery System (Option)
When storing the saw where temperatures may drop
below freezing, blow out the water lines to prevent damage
to the water delivery system.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
1. Connect the water supply hose to the water inlet (garden
hose) fitting on the left side of the saw, (Item 20, Figure 4).
2. Verify that the water hose on the saw is connected to the
Blade Guard, (Figure 15), and that the water hoses or tubes
are pointed into both Blade Flanges.
Ensure that the hose ends maintain a 45
o
angle and maintain a
light contact with the surface of the blade.
Installing the Flange Guard
The Flange Guard protects the Blade Flange not in use.
1. Slide the Flange Guard onto the Guard Mounting Tab on
the frame. (See Figure 19.)
2. Verify that the Blade Flange not in use is secured to the
Blade Shaft, by tightening the mounting bolt.
Figure 19. The Flange Guard Installed
1
2
3
5. The lever on the left side of the control panel regulates
water flow volume. The lever on the right side of the control
panel turns the water ON and OFF.
6. If the saw is equipped with an optional water pump, the
ON/OFF switch is located on the control panel next to the
water ON/OFF control valve.
3. Ensure that the hose ends maintain a 45
o
angle and
maintain a light contact with the surface of the blade. (Figure
18.)
Figure 20. Optional Bladeguard Water Tube