Multiquip MVH-120GH Chainsaw User Manual


 
MVH-120GH — OPERATION AND PARTS MANUAL — REV. #03 (10/24/07) — PAGE 17
MVH-120GH — INITIAL START-UP
5. Grasp the starter grip (Figure 14) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding the compression point. Rewind the rope a little from
that point and pull out sharply.
Figure 14. Starter Grip
6. If the engine has started, slowly return the choke lever
(Figure 12) to the
CLOSED
position. If the engine has not
started, repeat steps 1 through 5.
7. Before the compactor is put into operation, run the engine for
3 to 5 minutes.
8. Check for abnormal engine noises or fuel leaks.
Stopping the Engine
1. Place the
throttle lever
(Figure 13 or 13A) in
slow
position,
and listen for the engine speed to decrease.
2. Place the
engine ON/OFF switch
(Figure 11) in the
"OFF"
position.
3. Place the
fuel valve lever
(Figure 10) in the
"OFF"
position.
CAUTION
z
DO NOT pull the starter rope all the way to the end.
z
DO NOT release the starter rope after pulling. Allow
it to rewind as soon as possible.
CAUTION
NEVER stop the engine suddenly while working at
high speeds.