Multiquip MVH-120GH Chainsaw User Manual


 
PAGE 16 — MVH-120GH — OPERATION AND PARTS MANUAL — REV. #3 (10/24/07)
l
D
1. Place the
fuel valve lever
(Figure 10) in the "ON" position.
Figure 10. Fuel Valve Lever
2. Place the
Engine ON/OFF switch
(Figure 11) in the "ON"
position.
Figure 11. Engine ON/Off Switch
3. Place the
Choke Lever
(Figure 12) in the "OPEN" position.
Nnnn
The CLOSED position of the choke lever
enriches the fuel mixture for starting a COLD
engine. The OPEN position provides the correct
fuel mixture for normal operation after starting,
and for restarting a warm engine.
Figure 12. Choke Lever
4. Place the
throttle lever
(Figure 13) halfway between
fast
and
slow
.
Figure 13. Engine Throttle Lever
MVH-120GH — INITIAL START-UP
Some compactor units may be equipped with
a throttle lever (Figure 13A) that is located in
the vicinity of the hydraulic pump. This throttle
lever is connected to the engine throttle
linkage.
Figure 13A. Engine Throttle Lever
DO NOT attempt to run the compactor until the Safety and
Initial Start-up sections have been read,
CAUTION