Multiquip MP2050E3 Pole Saw User Manual


 
PAGE 26 — MQ MP2 MASONRY SAW — OPERATION MANUAL — REV. #2 (03/12/13)
4. Rotate the
throttle lever
(Figure 22) halfway between
fast
and
slow
for starting. All cutting is done at
full
throttle
. The engine governor speed is factory set to
ensure optimum blade operating speeds.
Figure 22. Throttle Lever
3. Place the
Choke Lever
(Figure 21) in the CLOSED
position.
Figure 21. Choke Lever
MP2 MASONRY SAW — STARTUP/SHUTDOWN (GASOLINE ENGINE)
Figure 19. Engine Fuel Valve Lever
Figure 20. Engine ON/OFF Switch
2. Place the
Engine ON/OFF switch
(Figure 20) in the ON
position.
The CLOSED position of the
choke lever enriches the fuel
mixture for starting a COLD
engine. The OPEN position
provides the correct fuel mixture
for normal operation after starting,
and for restarting a warm engine.
ALWAYS use the
water feed system
unless special
dry cut
blades are being used. If dry cutting is required
disconnect water pump.
1. Place the
fuel valve lever
(Figure 19) to the ON position.
Read and fully understand this manual
before
starting or attempting to
operate the saw
.
Before starting the saw's electric
motor make sure that the
Safety
,
General Information
,
Inspection
and
Pre-setup
sections have been completed and understood. DO
NOT proceed until the above mentioned sections have
been completed.
CAUTION - Read this Manual before Starting!
Start-up Gasoline Engine
CAUTION - Dry Cutting Precautions
NOTE
NEVER place hands and fingers near
the cutting blade. The possibility exist
of severe bodily harm if hands and
fingers come in contact with rotating
saw blade.
WARNING - Amputation Hazard
ALWAYS ensure that the cutting blade has
been mounted correctly and that it is raised
above the surface you are about to cut.
CAUTION - Blade Guard Safety