Multiquip MP2050E3 Pole Saw User Manual


 
PAGE 22 — MQ MP2 MASONRY SAW — OPERATION MANUAL — REV. #2 (03/12/13)
4. The MP2 Masonry Saw is now ready for
wet cutting
.
ALWAYS use a
grounded (3-wire)
extension cord and
MAKE CERTAIN that the motor is connected to a
properly grounded electric circuit. If possible use a
ground fault circuit interrupter to protect the operator
from possible
electric shock
.
Dry Cutting (Electric Saws Only)
1. Un-plug the water pump power cord from the outlet
receptacle on the electric motor conduit box.
NEVER
dry cut
with the pump connected to a AC power
source. Running the pump
dry
will
damage
the pump.
Always disconnect the pump's power cord when dry
cutting.
2. The MP2 Masonry Saw is now ready for
dry cutting
.
Connecting the Power (Figure 10)
1. Place the power ON/OFF switch (Figure 11) in the OFF
position (down).
Figure 11. Power ON/OFF Switch (OFF)
2. Connect an extension cord (Figure 13) of adequate
current carrying capacity to the power plug on the
electric motor.
MP2 MASONRY SAW — PRE-SETUP (ELECTRIC MOTORS)
SEZISDROCNOISNETXE.4ELBAT
ROTOM EGATLOV
'05
GNOL
'57
GNOL
'001
GNOL
ESAHPELGNIS-PH5 032 01.oN 8.oN 6.oN
ESAHP3-PH5 032 21.oN 01.oN 8..oN
ESAHP3-PH5 064 41.oN 21.oN
.oN
01
ESAHP3-PH5.7 032 01.oN 8.oN
.oN
6
ESAHP3-PH5.7 064 21.oN 01.oN
.oN
8
CAUTION - Grounding Electric Motors
CAUTION - Dry Cutting & Water Pump
NEVER grab or touch a live power
cord with wet hands, the possibility
exists of electrical shock,
ectrocution, and even
death!
DANGER - Electrocution Hazard
NEVER use
a damaged
or
worn
extension cable when connecting
to a power source. Defective cables may cause damage
to the saw's electric motor or electrical shock.
MAKE CERTAIN that the correct size extension cord
is used. Undersize wires will burn out motors. Use Table
4 to determine the correct extension cord size.
CAUTION - Dry Cutting & Water Pump