Filter
Top Products
PAGE 18 — MQ MP2 MASONRY SAW — OPERATION MANUAL — REV. #2 (03/12/13)
MP2 MASONRY SAW — ELECTRIC MOTOR COMPONENTS
Figure 4. Electric Motor Components
Heavy Duty Electric Motors
The MP2 Saw can be equipped with several different models of electric motors. Figure 4 shows the basic components of
the electric motor. Refer to the manufacturers electric motor manual for instructions & details of operation and servicing.
NEVER grab or touch a live
power cord with wet hands, the
possibility exists of electrical
shock, ectrocution, and even
death!
DANGER - Electrocution Hazard
NEVER use
a damaged
or
worn
extension cable when
connecting to a power source. Defective cables may
cause damage to the saw's electric motor or electrical
shock.
4. Water Pump AC Power Receptacle – Plug the electric
water pump into this receptacle to provide power to the
pump during saw operation. Unplug the electric water
pump from this receptacle when dry cutting.
5. Electric Motor Wiring Pigtail – The saw motor ships
with cable "pigtails." Have an licenced electrician supply
and install the appropriate NEMA connector.
1. Electric Motor – The MP2 saw can be operated with
either a Single Phase or Three Phase 230V motor. Only
qualified electricians should service the motor.
WARNING - Wiring Three Phase Motors
All saws equiped with
three phase motors
should be wired
by a qualified electrician and correct motor rotation verified
before operating the saw.
2. Power ON/OFF Box – To turn on the saw, place switch
in the ON position. Place in the OFF position to
shutdown the saw.
3. Electric Motor Reset Switch – This switch is part of
the thermal overload protection for the electric motor. If
the motor overheats and shuts down, press this switch
to reset the motor, after allowing the motor to cool
down.This is used on
Single phase
electric saws only.