Filter
Top Products
PAGE 22 — MOONLIGHT LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #0 (10/27/06)
MOONLIGHT LIGHTING SYSTEM — SETUP
POLE HEIGHT ADJUSTMENT (MBP)
1. To adjust the height of the pole, loosen the height ad-
justment knob (see Figure 27) on the MBP mounting
pole and slowly pull up the inner pole to the desired
height. Tighten the height adjustment knob.
When raising or lowering the pole, keep hands and fingers
clear of the section between the pole and the inner pole.
This will prevent hands and fingers from getting pinched.
CAUTION - Pole Safety
MAST HEIGHT ADJUSTMENT (MBC and MBS)
1. To adjust the height of the mast on the MBC cart or
MBS stand, rotate the winch handle until the mast is at
the desired height (see Figure 28).
Figure 27. MBP Pole Height Adjustment
KNOB
PULL OUT
INNER POLE
TOADJUST
HEIGHT
Figure 28. MBC and MBS Mast Height Adjustment
ROTATE
WINCH HANDLE
When raising or lowering the mast, keep hands and fingers
clear of the various mast sections, this will prevent hands
and fingers from getting pinched.
CAUTION - Mast Safety
1. To adjust the height of the pole on the MBT tripod, re-
move the pin that holds the pole in place and loosen
the knob (see Figure 29). Adjust the pole to the desired
height and tighten knob to secure pole. Put back the
pin to lock pole in place.
POLE HEIGHT ADJUSTMENT (MBT)
Figure 29. MBT Pole Height Adjustment
REMOVE PIN TO
RELEASE POLE
LOOSEN KNOB TO
ADJUST POLE HEIGHT
ALWAYS make sure that the mounting pole, cart, stand
or tripod is properly secured to prevent tipping! Use
sandbags or stakes to secure the mounting accessory
as necessary.
DANGER - Mounting Accessory Tipping