Filter
Top Products
PAGE 16 — MOONLIGHT LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #0 (10/27/06)
MOONLIGHT LIGHTING SYSTEM — ASSEMBLY
MBC CART ASSEMBLY
If the Moonlight balloon is to be mounted into the MBC Cart,
perform the following assembly procedure before installing
the balloon.
1. Step on the ON position of the brake on the wheel of
the MBC cart to keep the cart in place during assem-
bly. See Figure 6.
2. Install the T-handle as shown in Figure 7 and tighten
the bolt.
3. Install the clamp as shown in Figure 8 and tighten with
bolt. Push handle towards clamp to secure handle in
place as shown in Figure 9.
Figure 6. Setting the Brake On
Figure 7. T-Handle Installation
Figure 8. Clamp Installation
4. Slide mast into the slot in the cart as shown in Figure 10.
Tighten the 4 bolts to keep the mast in place.
5. Remove the pin near the top of the mast and insert the
extrusion on the top of the mast. Reinsert the pin to
hold extrusion in place. See Figure 11.
Figure 9. Clamped T-Handle
STEP ON “ON”
PEDALTO
ACTIVATE
BRAKE.
SCREW
T-HANDLE
NUT
CLAMP
SCREW
NUT
Figure 10. MBC Mast Installation
T-HANDLE
CLAMP
MAST
TIGHTEN BOLTS
(4 PLACES)
Figure 11. Extrusion Installation
EXTRUSION
PIN