Filter
Top Products
PAGE 18 — MOONLIGHT LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #0 (10/27/06)
MOONLIGHT LIGHTING SYSTEM — ASSEMBLY
MBT TRIPOD ASSEMBLY
The MBT Tripod can be used with the MB150 and MB400
Balloons. The MBT Tripod is shipped pre-installed.
1. To secure the legs in place, loosen the knob (see Figure
17), pull the legs out and tighten the knob.
Figure 17. MBT Tripod Adjustments
6. When balloon and mast are removed and stored, the
MBS stand legs can be stowed as shown in Figure 16.
Figure 16. Stand Legs Stored
4. Install the winch handle on the mast as shown in
Figure 12.
5. The stand is now ready for the balloon to be installed.
Proceed to BALLOON INFLATION section.
ALWAYS MAKE SUREAREA
ABOVE MAST IS OPEN
AND OF OVERHEAD
. THE POSSIBILITY
EXISTS OF ELECTROCUTION,
SHOCK, EVEN DEATH! IF THE
BALLOON COMES IN CONTACT
WITH HIGH VOLTAGE LINES.
CLEAR
POWER LINES
TO PREVENT SERIOUS
INJURY OR DEATH
DANGER!
MAST
ALWAYS MAKE SUREAREA
ABOVE POLE IS OPEN
AND OF OVERHEAD
. THE POSSIBILITY
EXISTS OF ELECTROCUTION,
SHOCK, EVEN DEATH! IF THE
BALLOON COMES IN CONTACT
WITH HIGH VOLTAGE LINES.
CLEAR
POWER LINES
TO PREVENT SERIOUS
INJURY OR DEATH
DANGER!
POLE
2. The tripod is now ready for the balloon to be installed.
Proceed to BALLOON INFLATION section.
TWIST KNOB
TO LOCK LEGS