PAGE 32 — DCA-70SSJU SERIES — OPERATION AND PARTS MANUAL (STD) — REV. #5 (06/03/03)
Generator Output Voltages
A wide range of voltages are available to supply voltage for
many different applications. Voltages are selected by using
the
voltage selector
switch (Figure 15). To obtain some of
the voltages as listed in Table 6 (see below) will require a
fine adjustment using the
voltage regulator
(VR)
control
knob
located on the control panel.
Voltage Selector Switch
The
voltage selector
switch (Figure 15) is located above
the UVWO Hard Wire Hook-up Panel. It has been provided
for ease of voltage selection.
CAUTION:CAUTION:
CAUTION:CAUTION:
CAUTION:
NEVER change the position of the
voltage
selector switch
while the engine is running.
ALWAYS place circuit breaker in the open
position before selecting voltage.
Voltage Selector Switch Locking Button
The voltage selector switch has a locking button to protect
the generator and load from being switched while the engine
is running. To lock the voltage selector switch,
press
and
hold
the
red button
located at the bottom of the switch.
Figure 15. Voltage Selector Switch
DCA-70SSJU SERIES — GENERATOR OUTPUTS
Generator Amperage
Tables 7 and 8 describe the generator’s current output capa-
bility for both 1Ø-phase and 3Ø phase applications.
elbaliavAsegatloV.6elbaT
esahPeerhT
)elbahctiwS(
TLOV802TLOV022TLOV042TLOV614TLOV044TLOV084
esahPelgniS
)elbahctiwS(
TLOV021TLOV721TLOV931T
LOV042TLOV452TLOV772
erepmArotareneG.7elbaT
Ø1—sgnitaR
WkV042V021
0238661
52401802
03522052
53541192
04661333
54781573
05802714
)xaM(06052005
Ø3—sgnitaRerepmArotareneG.8elbaT
WkV802V042V084
02950603
52785783
034010954
5312150135
0493102106
5465163186
0547125167
0680218199