Filter
Top Products
PAGE 48 — DCA-40SSAI — PARTS AND OPERATION MANUAL — FINAL COPY (07/09/01)
9. The generator's frequency meter (Figure 43) displays
the 60 cycle output frequency in HERTZ.
Figure 44. Voltage Meter (Volts)
10. The generator's voltage meter (Figure 44) displays the
120 VAC in VOLTS. If the voltage is not within the
specified frequency tolerance, use the voltage
adjustment control knob (Figure 45) to increase or
decrease the desired voltage.
Figure 39. Voltage Selection Switch
Figure 45. Voltage Adjust Control Knob
4. Close all engine enclosure doors (Figure 38).
Figure 38. Engine Enclosure Doors
DCA-40SSAI — GENERATOR START-UP PROCEDURE
5. Check the voltage selection switch (Figure 39) is
at the desired voltage.
6. Turn and push the engine throttle control lever
(Figure 40) to ‘Low’.
7. Preheat the engine by turning the ignition key to
the left. Once the preheat lamp luminates, turn the
key to the farthest right to start the engine. Once
the engine start to crank, release the key to
‘operation’ (Figure 41).
8. Once the engine is warm and the engine is
running properly, pull and turn the engine throttle
control lever to ‘High’ (Figure 42).
Figure 40. Engine Throttle Control Lever (low)
Figure 41. Starter Switch
Figure 42. Engine Speed Switch (high)
Figure 43. Frequency Meter (Hz)