Filter
Top Products
PAGE 22 — GB113BC GLOBUG LIGHTING SYSTEM — OPERATION AND PARTS MANUAL — REV. #5 (01/16/12)
Removing the Lamp/Balloon Assembly
1. Place the lamp/ballon assembly in the STOW position.
2. With a 5 mm allen wrench, loosen the set screw (Figure 22) that
secures the lamp to the mast adapter stand.
3. Disconnect the lamp power cable as shown in Figure 22,
and slide the balloon/lamp forward from the mast adapter
stand. Place lamp/balloon assembly on a suitable work
bench that is free of dirt, and sharp objects that could
damage the balloon.
Removing the Lamp
1. Expose the balloon (Figure 23) by pulling down on the
velcro tabs and unzip the protective cover as shown in
Figure 18. Next, fold the protective cover into itself and
zip.
Figure 22. Removing the Balloon/Lamp
Figure 24. Exposing the Balloon
Figure 24. Removing the Lamp Guard
3. Push down and hold the lamp holder (spring loaded) away
from the lamp (Figure 25). Unscrew the lamp (turn counter-
clockwise) from the lamp socket.
Figure 25. Removing the Lamp
CAUTION - READ SAFETY GUIDELINES
Before performing any maintenance
procedures, be sure to READ the lamp,
balloon, and general safety guidelines in
this manual. Failure to
read
and
understand
these safety guidelines
could cause severe equipment damage
and bodily harm.
CAUTION - BALLOON ZIPPER SAFETY
DO NOT use excessive force when zipping or
unzipping the balloon. The possibility exists
of the zipper tearing, which would make the
balloon unusable.
2. Unzip the zipper (Figure 23) at the bottom of the balloon
and roll the balloon envelope upwards to expose the lamp
(Figure 24). Remove the lamp guard to gain access to the
lamp.. DO NOT use excessive force when un-zipping
the balloon.
MAINTENANCE