Filter
Top Products
GB113BC GLOBUG LIGHTING SYSTEM — OPERATION AND PARTS MANUAL — REV. #5 (01/16/12) — PAGE 19
5. To position the balloon, simply loosen
the adjustment lever by turning it counter-
clockwise and either push down or up
on the lever. Pushing
down
on the lever
will cause the balloon to rise. Pushing
up
on the lever will allow the balloon to
be lowered. See insert A in Figure 10.
For circular positioning, swing the lever
to the desired position. See insert B in
Figure 11.
Figure 10. Positioning the Balloon
6. Before raising the mast, make sure the mast set screw
(Figure 11) is securely tightened (use an 5mm-allen
wrench to tighten). This will prevent the balloon/lamp
assembly from falling off. In addition make sure the power
cable from the generator is connected to the lamp power
cable.
Figure 11. Mast Set Screw/Power Connections
7. Using the mechanical winch (Figure 12),
raise
the mast
to the desired height. Turn winch handle clockwise to
raise mast.
Figure 12. Mechanical Winch Handle
CAUTION - MAST PINCH POINT
When raising or lowering the mast, keep hands and fingers
clear of the various mast sections, this will prevent hands
and fingers from getting pinched.
SETUP