Filter
Top Products
Self-propelled Chipper Shredder Vacuum
7
3.13. Remove three self tapping screws holding trans-
mission brace to the frame using an 3/8 socket.
3.14. Remove the two phillips screws holding the
transmission to the brace. See Figure 3.14.
3.15. Remove barbed fitting holding the variable
speed cable to the transmission bracket.
See Figure 3.15.
3.16. Disconnect Z-fitting from transmission using
needle nose pliers (This is the variable speed
cable).
NOTE: Rotating the collar counter-clockwise will
aid in removal.
NOTE: Z-fitting must be installed from the bot-
tom of the speed control collar.
Figure 3.14
Phillips screw
Self tapping screws
Figure 3.15
Barbed
fitting
Variable speed cable
3.17. Remove spring from transmission actuating arm.
(This is the self propel clutch cable)
See Figure 3.17.
3.18. Push the hexagonal drive axle bushings out of
each side of frame. See Figure 3.18.
Figure 3.17
Self propel clutch cable
Actuating arm
Figure 3.18
Bushing