Filter
Top Products
Self-propelled Chipper Shredder Vacuum
6
3.7. Safely support rear of the unit so that the rear
wheels are off the ground, and remove rear hub
caps. See Figure 3.7.
3.8. Using a 1/2” wrench and a 9/16” wrench remove
the shoulder bolts, washers, and rear wheels.
See Figure 3.8.
NOTE: A heavy washer goes between wheel
and outside of frame.
3.9. Cross-bar is also secured by the rear wheel
shoulder bolts. It can be removed as the rear
wheels are removed.
NOTE: The rear cross bar is shorter than the
front cross bar.
3.10. Remove retaining ring holding drive gear and
dowel pin on axle. See Figure 3.10.
NOTE: There are right hand and left hand drive
gears
3.11. Remove dust cover
NOTE: Rim on dust cover faces outboard
3.12. Remove E-clip and flat washer from axle.
See Figure 3.12.
Figure 3.7
4X4 supports
Figure 3.8
Heavy washer
Dust cover
Figure 3.10
Right hand drive gear
Dust cover
Figure 3.12
E-clip
Flat washer
Bushing