MTD 28 Snow Blower User Manual


  Open as PDF
of 56
 
9
3
Setting Up
Your Snow
Thrower
WARNING
Never use your hands
to clean snow and
ice from the chute
assembly or auger
housing.
IMPORTANT
If the tire pressure is not
equalinbothtires,theunit
may not travel in a straight
path and the shave plate
may wear unevenly.
A
B
Figure 3-11
• Repeataugercontroltesttoverifyforproper
adjustment. Repeat previous steps to adjust more, if
necessary.
Skid Shoes
Position the skid shoes based on surface conditions.
Adjust upward for hard-packed snow. Adjust downward
when operating on gravel or crushed rock surfaces. See
“Making Adjustment” Section.
Tire Pressure (Pneumatic Tires)
The tires are over-inflated for shipping purposes.
Check the tire pressure before operating the snow
thrower. Refer to the tire side wall for tire manufacturer’s
recommended psi and deflate (or inflate) the tires as
necessary.
• LoosentheNylocknutonthedrivecontrolcableand
unthread the cable one full turn. See Figure 3-13.
• Recheckadjustment.
• RetightentheNylocknuttosecurethecablewhen
correct adjustment is reached.
NOTE: For more details, refer to Drive Control Adjust-
ment in the Adjustment Section of this manual.
Auger Control
Check the adjustment of the auger control as follows:
• Whentheaugercontrolisreleasedandinthe
disengaged “up” position (see Figure 3-11B), the cable
should have very little slack, but should NOT be tight.
See Figure 3-12.
WARNING:Do not over-tighten the
cable. Over-tightening may prevent the
auger from disengaging and compro-
mise the safety of the snow thrower.
• Inawell-ventilatedarea,startthesnowthrowerengine
as instructed on page 12.
• Whilestandingintheoperator’sposition(behindthe
snow thrower) engage the auger.
• Allowtheaugertoremainengagedforapproximately
ten seconds before releasing the auger control.
Repeat this several times.
• Withtheaugercontrolleverinthedisengaged“up”
position, walk to the front of the machine.
• Confirmthattheaugerhascompletelystopped
rotating and shows no signs of motion.
IMPORTANT: If the auger shows any signs of rotating,
immediately return to the operator’s position and shut
off the engine. Wait for all moving parts to stop before
readjusting the auger control cable.
• Toreadjustthecontrolcable,unhookthespring(found
on the end of the auger cable) from the auger actuator
bracket. See Figure 3-12.
• Pushthecablecouplerthroughtheendofthespring
to expose the lock nut. See Figure 3-13.
• ThreadtheNylocknutoutward(downthecoupler)
three full turns to provide more slack in the cable and
reattach the spring to the bracket.
Figure 3-13
Figure 3-12
Drive
Auger
A
B
A - For models with steel panels.
B - For models with plastic panels.
 previous next