Filter
Top Products
-- 5 --
Blower Outlet
Rib
Groove
2. Secure the tube by turning the bolt clock-
wise.
3. Align the slots on the lower blower tu be
with the tabs on the upper blower tube.
Upper Blower Tube
Tab
Lower Blower Tube
Slot
Tube clamp
bolt and nut
4. Slidethelower blowertubeonto theupper
blower tube.
5. Turnthe lower blower tube clockwise until
a c lick is felt to secure the lower blower
tube to the upper blower tube.
NOTE: When the upper and low er blowe r
tubes are assembled together properly, the
arrows on both tubes will be aligned.
6. Toremovethetubes,turnthe boltcounter-
clockwise toloosen thetubes; removethe
tubes.
HIGH--SPEED NOZZLE ASSEMBLY
When greater air s peed is desired, use the
high--speed nozzle.
1. Alignthe slots on the nozzle with t hetabs
on the lower blower tube.
High--Spee
d
Nozzle
Tab
Slot
Lower Blower
Tube
2. Slide the nozzle onto the lower blower tube.
3. Turn the nozzle c lockwise until a click is
felt tosecure thenozzle tothe lower blow-
er tube.
VACUUM ASSEMBLY
VACUUM BAG A SSEMBLY
1. Open the zipper on the vacuum bag and
insert the elbow tube.
2. Push the small end of the elbow tube
through the small opening in the bag.
Small Opening
Zipper
Opening
Elbow
Tube
Rib
NOTE: Make sure edge of the small open-
ing is flush against the flared area of the el-
bow tub e, and the rib on the elbow tube is
on the bottom.
3. Closethezipperonthebag.Makesurethe
zipper is closed completely.
4. Remove blower tubes from engine.
Rib
Groove
5. Inserttheelbowtubeintothebloweroutlet.
Make sure elbow tube rib is aligned with
the blower outlet groove.
6. Turnknobclockwisetosecureelbowtube.
VACUUM TUBE ASSEMBLY
WARNING: Stopengine and be sure
the impeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or r em ove the vacuum or
blower tubes. The rotating blades can cause
serious injury.
1. Insert thetipofascrewdriver intothelatch
area of the vacuum inlet.
Latch
Area
Blower
Outlet
Latch Area
Vacuum Inlet Cover
2. Gentlytilt thehandleofthe screwdriverto-
ward the front of the unit t o release the
latch while pulling up on the vacuum inlet
cover with your other hand.