Filter
Top Products
3-1. “P” HANDLE ASSEMBLY
1. To install handle onto unit, you will need the following
components from your user kit: “P” handle (A & B),
screws (C) and nuts (D). (Figure 3-1).
2. Install the handle (B) on the shaft 6.0” to 7.87” (160-
200mm) from throttle and tighten the 2 screws (C) and
nuts (D).
3-2. DEBRIS SHIELD
WARNING
The debris shield must be installed (Figure 3-2A) to prop-
erly dispense cutter line and protect operator.
Shield fits snug on shaft. Some force may be required.
1. Seat shield (A) onto shaft bracket (B). (Fig. 3-2A)
2. Insert bolt (C), washer (D), lock washer (E) and wing
nut (F), tighten securely. (Fig. 3-2B)
6 7
2 - SAFETY PRECAUTIONS 3 - ASSEMBLY INSTRUCTIONS
Use of these personal safety items is highly recommended to
reduce the risk of accidental injury.
Minimum operating distance
2-3. INTERNATIONAL SYMBOLS
Do not use blade on this unit.
Read the User Manual.
Pump the primer bulb 10 times.
3-1A
A
B
C
D
3-2A
B
3-2B
F
A
E
D
C