Filter
Top Products
get into it!
The following instructions are required to be printed by Underwriters
Laboratories (UL) as a condition of the listing of this product. They
contain important safety information. We strongly encourage you to
read and apply them.
IMPORTANT SAFETY
INSTRUCTIONS
WHEN INSTALLING AND USING THIS ELECTRICAL
EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD
ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:
1. READ AND FOLLOW ALL
INSTRUCTIONS
2. WARNING: To reduce the risk of injury, do not permit children to
use this product unless closely supervised at all times.
3. DANGER: RISK OF CHILD DROWNING. Extreme caution must
be exercised to prevent unauthorized access by children. To avoid
accidents, ensure that children cannot use the spa or hot tub unless
they are supervised at all times.
120 VOLT, CORD CONNECTED MODELS
4. DANGER: RISK OF INJURY. Connect only to a grounded source.
5. Do not bury the power cord.
6. WARNING: To reduce the risk of electric shock, replace a damaged
cord immediately.
7. A ground terminal (pressure wire connector) is provided on the
surface of the control box inside the equipment compartment. This
connector should be bonded with a minimum No. 8 AWG (8.4mm
2
)
solid copper wire between this unit and any metal ladders, metal
water pipes, metal enclosures of electrical equipment, conduit, or
metal equipment within five feet (1.5m) of the spa. If the spa is
located on a reinforced concrete pad, the reinforced steel should
also be bonded to the ground terminal.
8. WARNING: Your spa is equipped with a ground fault circuit inter-
rupter (GFCI) on the end of the power supply cord. Before each use
of the spa, with the plug connected to the power supply and the
unit operating, press the “test” button. The unit should stop operat-
ing and the GFCI power indicator will go out. Wait thirty seconds and
then reset the GFCI by pressing the “Reset” button. The GFCI
power indicator will turn on, restoring power to the spa. If the
interrupter does not perform in this manner, it is an indication of an
electrical malfunction and the possibility of an electric shock. Discon-
nect the plug from the receptacle until the fault has been identified
and corrected.
safety instructions
4