Filter
Top Products
get into it!
SUCTION GUARDS
The suction guard(s) in the footwell of your spa is
an opening through which the jet pump draws
water. Suction fittings are equipped with a safety
guard. Suction through the fittings can be strong.
The safety guard(s) must remain in place and
undamaged. A fitting with a damaged guard(s) can
be dangerous, especially to small children or people
with long hair. Should any part of the body become
drawn to a fitting, turn the jet pump
off immediately.
Long hair should be restrained in a bathing cap,
never allow it to float freely in the spa. Replace any
missing or damaged suction guard(s).
NOTE: It is normal for the flow rates of the suction
fittings to vary from strong to barely noticeable.
ELECTRICAL REQUIREMENTS
It is the responsibility of the spa owner to ensure
that all electrical connections are made in accor-
dance with all electrical codes in effect at the time
of installation.
120 Volt:
120V units must only be connected to
a properly grounded, grounding type
15 amp dedicated receptacle. 120V
equipment is designed to operate on
60Hz alternating current only at a
voltage of 120, 12.5 amp. maximum
load. Only use the cord provided with
the spa, do not use an extension cord.
To Convert 120V to 240V:
All connections must be made by a licensed
electrician.
1. Disconnect power by unplugging from
receptacle and remove cord from terminal
block.
2. Remove white wire connected to J11 and J32
completely and discard.
3. Install 240V power line as indicated on page 14.
4. Set dip switch 10 to off position.
5. For units for use in other than single-family
dwellings, a clearly labeled emergency switch
shall be provided as part of the installation. The
switch shall be readily accessible to the
occupants and shall be installed adjacent to,
within sight of, and at least five feet (1.52 m)
from the spa.
installation instructions
Safety guard of
suction fitting must
remain in place.
13