Filter
Top Products
get into it!
OUTDOOR AND PATIO INSTALLATION
To install the spa outdoors, we recommend a
reinforced concrete pad at least four inches thick.
The reinforcing material should be attached to a
#8 AWG bonding wire per national and local
electrical code.
If you place the spa on the ground, even tempo-
rarily, place concrete pavers under the entire
bottom of the spa. The concrete pavers should be
a least two inches thick and level across the entire
surface. The spa will inevitably settle and not
remain level on this surface, thus it’s important to
get it onto a solid foundation as soon as possible.
DECK INSTALLATION
Be sure the deck can support the weight of your
filled spa by checking the deck’s maximum load
capacity. Consult a qualified building contractor or
structural engineer. Minimum requirement is 100
pounds per square foot.
INDOOR INSTALLATION
There are special requirements if you place your
spa indoors. Flooring material must provide
adequate traction when wet. Proper drainage is
essential to prevent water puddling. Proper ventila-
tion to the area is required. The addition of a ventila-
tion system is recommended. Please see your
contractor for details.
installation instructions
11