Filter
Top Products
get into it!
SHUT-OFF VALVES
Your spa is equipped with shut-off valves (see
EQUIPMENT DIAGRAM) that shut off the water
flow to the equipment system for dealer service.
At times, a new spa or one that has recently been
serviced, may have the shut-off valves partially
closed which can restrict the water flow and
hinder jet performance. Be sure the valves are
fully open.
FREEZE PROTECTION
When a freeze condition is detected (which
occurs when the temperature in the heater
housing drops to 55°F (13°C) the jet pump is
automatically activated. In areas with extremely
cold winter conditions, your spa should be fine as
long as it is left running at normal operating tem-
peratures. For extra protection see your dealer for
an optional freeze sensor. If you plan to turn the spa
off, follow the instructions in this manual (see
SUSPENDED USE OR WINTERIZING YOUR SPA).
OVERHEATING
In the case of extended hot weather, the spa
water temperature may reach and maintain 104°F
to 106°F (40°C to 41°C) or higher. This is due to the
ambient temperature and the full insulation in the
spa cabinet. You may have the option of shorten-
ing the pump-run time. See SPA CONTROL
OPERATION for available options.
FILTER CARTRIDGE
Your portable spa is equipped with the Constant-
Clean™ Filtration system.
NOTE: It is very important that the components of
these filtration systems be installed properly in the
proper part of the spa.
1. Hold the Vortex filter cartridge and center it in
the opening of the filter housing.
2. Use the filter handle and turn the filter
cartridge clockwise to screw it in place. (Use
caution not to overtighten as damage may
occur to threads and is not covered under
warranty.)
3. Grasp the edge of the dome-shaped Vortex
filter top. Center it over the ring and gently
snap in place.
installation instructions
Shut-off valve in
open position
1) Center filter
cartridge over canister
2) Screw filter
cartridge in place
3) Snap Vortex filter top
in place
12