Filter
Top Products
6
Your MANTIS
®
XP Tiller comes
partially assembled. Full assembly will
take just a few minutes if you follow
the directions.
First, take all items out of the
carton. But do not remove the
cardboard from around the Tiller’s
base.
The list at the right, shows the parts
that come with your tiller. Check to
make sure you have them.
The bag of hardware is in the plastic
bag containing the Owner’s Manual and
Video.
To assemble your MANTIS Tiller,
you’ll need two 7/16" and one 3/8"
wrenches or sockets. We suggest that
you install all nuts and bolts only
“finger tight”
— that is, one-half to
one full turn — until you’ve
completed assembly. The nuts are
self locking, but you must use a
wrench to tighten them completely.
Assembly
WARNING•DANGER
IMPROPER ASSEMBLY OF THIS TILLER
CAN RESULT IN SERIOUS INJURY.
MAKE SURE TO FOLLOW ALL
INSTRUCTIONS CAREFULLY.
IF YOU HAVE ANY QUESTIONS
CONTACT OUR FACTORY AT
1-800-366-6268
!
!
Quantity Description *Key #
1 Upper Handle Assembly 2
1 Upper Handle Throttle Assembly 1
2 Lower Handles 6
1 Engine Assembly (includes Fender Guard,
Worm Gear Transmission & Tines) 20, 21, 39,
40, 55,
66, 67
1 Carrying Handle 42
1 Handle Brace 8
1 Bag of Hardware Containing:
2 Bolts (1” long) 47
4 Lock Nuts 48
2 Bolts (3” long) 49
2 Handle Clamps 51
1 Throttle Cable Clip 13
2 Round Head, Square Neck Bolts 52
2 Handle Knobs 53
1 Kickstand Assembly 69
1 Kickstand Top Bracket with 3/8” Bolts
**
70
*These numbers are the same numbers shown on the Parts
Layout on page 18.
**If applicable.
1
2
6
49
13
51
52
53
48
47
42
70
69
8
20
21
39 40 55 66 67
401764 XP Tiller-Cultivator_manual 5/18/10 10:51 AM Page 6