Filter
Top Products
DON’T FUEL, REFUEL, OR
CHECK FUEL WHILE
S
MOKING, OR NEAR AN
OPEN FLAME OR OTHER
IGNITION SOURCE.
INCORRECT ASSEMBLY.CAUTION: WHEN
ASSEMBLING THE HANDLES,
MAKE SURE FUEL TANK FACES
AWAY FROM OPERATOR. THIS
IS THE REAR OF THE TILLER,
REFER TO ASSEMBLY
I
NSTRUCTION ON PAGE 7.
CUTTING HAZARD; KEEP
F
EET AND HANDS AWAY
FROM ROTATING TINES.
WEAR EAR AND EYE
PROTECTION.
DO NOT OPERATE TILLER
INDOORS OR IN POORLY
VENTILATED AREA
DO NOT REACH YOUR
F
INGERS AND\OR
HANDS IN BETWEEN
THE TINE BLADES
ALWAYS REMOVE THE
OUTER TINES BEFORE
REMOVING THE
INNER TINES
R
EAD OWNER’S MANUAL
BEFORE USING TILLER, OR
PERFORMING ANY REPAIR
O
R MAINTENANCE. KEEP
OWNERS MANUAL IN A
SAFE PLACE.
DO NOT CARRY THE TILLER
I
N THIS POSITION.
WARNING • DANGER
IF THE TILLER IS USED IMPROPERLY OR SAFETY PRECAUTIONS
ARE NOT FOLLOWED, THE USERS RISK SERIOUS INJURY TO
THEMSELVES AND OTHERS. READ AND UNDERSTAND THIS
MANUAL BEFORE ATTEMPTING TO OPERATE THIS TILLER.
! !
WARNING • DANGER
OPERATION OF THIS EQUIPMENT MAY CREATE SPARKS THAT
CAN START FIRES AROUND DRY VEGETATION. A SPARK
ARRESTOR IS INSTALLED. THE OPERATOR SHOULD CONTACT
LOCAL FIRE AGENCIES FOR LAWS OR REGULATIONS
RELATING TO FIRE PREVENTION REQUIREMENTS.
!
!
A
n important part of the safety system incorporated in this tiller
a
re the warning and information decals found on various parts of the
tiller. These decals must be replaced in time due to abrasion, etc. It is your
responsibility to replace these decals when they become hard to read. The
location and part numbers (P/N) of these decals are illustrated below.
III. Safety Decal Information
4
P/N 400634
P
/N 400631
P/N 400635
IV. Warnings - Do’s
Read and understand the owner’s
manual. Pay particular attention to all
sections regarding safety.
1. Always keep a firm grip on both
handles while the tines are moving and/or
the engine is running. BE AWARE!! The
tines may coast after throttle trigger is
released. Make sure tines have come to a
complete stop and engine is off before
letting go of the tiller.
2. Always maintain a firm footing and
good balance. Do not overreach while
operating the tiller. Before you start to use
the tiller, check the work area for obstacles
that might cause you to lose your footing,
balance or control of the machine.
3. Thoroughly inspect the area where
equipment is to be used and remove all
objects, which can be thrown by the
machine.
4. Always keep area clear of children,
pets, and bystanders.
5. Always stay alert. Watch what you
are doing and use common sense. Do not
operate unit when fatigued.
6. Always dress properly. Do not wear
loose clothing or jewelry, they might get
caught in moving parts. Use sturdy gloves.
Gloves reduce the transmission of
vibration to your hands. Prolonged
exposure to vibration can cause numbness
and other ailments.
7. While working, always wear
substantial footwear and long trousers. Do
not operate the equipment when barefoot
or wearing open sandals.
8. Always wear ear and eye protection.
Eye protection must meet ANSI Z 87.1.
To avoid hearing damage, we recommend
hearing protection be worn whenever
using the equipment.
9. To reduce fire hazard, keep the
engine, and petrol/gas storage area free of
vegetative material and excessive grease.
10. Start the engine carefully,
according to the manufacturer’s
instructions and with feet well away from
tool(s).
11. Keep all nuts, bolts and screws
tight to be sure the equipment is in safe
working condition.
12. Use extreme caution when
reversing or pulling the machine towards
you.
13. Work only in daylight or good
artificial light.
14. Always be sure of your footing on
slopes.
15. Exercise extreme caution when
changing direction on slopes.
16. Always keep a safe distance
between two or more people when
working together.
17. Always inspect your unit before
each use and ensure that all handles,
guards and fasteners are secure, operating,
and in place.
18. Always maintain and examine your
tiller with care. Follow maintenance
instructions given in manual.
19. Always store tiller in a sheltered
area (a dry place), not accessible to
children. The tiller as well as fuel should
not be stored in a house
.
20. Always remove the outer set of tines
before removing the inner set of tines.
401764 XP Tiller-Cultivator_manual 5/18/10 10:51 AM Page 4