Makita UH303D Trimmer User Manual


 
ADDITIONAL SAFETY RULES FOR CHARGER
1.
The Makita charger Model
DC122
is specifically designed to charge only
the Makita battery 121 or
122.
Do not attempt to charge any other battery
with this charger.
2.
Handle the charger carefully. Do not drop or strike
it.
3.
Never carry the charger by cord or yank
it
to disconnect from receptacle.
4.
Keep cord from heat, oil, chemicals, and sharp edges.
5. Use only a power source of the same voltage as indicated on the nameplate
6. Do not attempt to use a step-up transformer, an engine generator or DC
7.
Charge the battery at a room temperature of 10°C (5OOF)
-
4OoC (104OF).
8.
Do not charge in place exposed to direct sunlight.
9.
Do not allow the charger to get wet.
IO.
Do not charge inside a box or container of any kind.
11. Do not charge near volatile, flammable material such as gasoline, paint, gas,
12.
Do not charge on top of paper, carpet, vinyl sheeting, cloth materials, etc.
13.
Do not allow anything to cover or clog the charger vents. Do not attempt
14.
Do
not charge
in
dusty place.
15. Stop charging immediately if you notice anything abnormal. Ship or take the
charger and the battery to your nearest Makita Service Center or Distributor
for checking them.
of the charger when charging.
power receptacle.
adhesive, etc.
to insert anything into the vents.
16.
Do not attempt to disassemble or make modifications to the charger.
17. Do not put any metal objects
or
foreign matter into the inlet of the charger.
Short-circuit
will
occur, causing a burn injury and charger breakdown.
SAVE THESE INSTRUCTIONS.
6