Filter
Top Products
P 6/ 8
Repair
[2] DISASSEMBLY/ASSEMBLY
[2]-3. Shear blade assembly
1. Adjust Crank complete to
the position as drawn below.
Joint of Housing set (L)
and Housing set (R)
2. Align the Holes of Shear blade A and B
to the Hole of Guide plate in order to set
M4 Pan head screw as a positioning pin.
M4 Pan head
screw
Shear blade B
Guide plate
Shear blade A
Crank complete
M4 Countersunk
head screw
Shear blade
assembly
4. Tighten M4 Countersunk head screws.
DISASSEMBLING
(1) Pull the rear portion of Base frame toward rear side designated with arrow. (Top left in Fig. 2)
(2) With pressing Lock lever, turn under cover complete to the unlocked position. (Top right in Fig. 2)
(3) Disassemble Under cover, and then remove Shear blade assembly. (Center left in Fig. 2)
Fig. 10
ASSEMBLING
(1) Mount Shear blade assembly. (Fig. 10)
3. Mount Shear blade assembly
with fitting the loops of Shear
blades A and B into Crank
complete
Fig. 11
(2) Mount Under cover complete. (Fig. 11)
5. Put Under cover complete on the bottom of
Housing set as drawn below.
6. With pressing Lock lever, turn Under cover complete
toward the locking position as drawn below.
Lock lever
Under cover
complete
Unlocked position
Locking position