Makita RBC310 Trimmer User Manual


 
4.
Hook the bent portion of the nylon cord into the
notch in the center plate of the spool. Wind the nylon
cords firmly and snugly on the spool in the direction
of the "WIND CORD LH
@"
engraved on the spool.
(Note)
Do not wind the nylon cords in the opposite direc-
tion of the "WIND CORD
LH
-''
engraved on the
spool. Do not overlap or twist the two nylon cords.
They will not feed out properly.
5.
Wind both nylon cords firmly and snugly until the
spool is full to the outer edge of the center plate.
Leave approx 120
mm
(4.314") of both nylon cords
unwound on the spool. Carefully prevent both nylon
cords from coming loose on the spool. Pass the end
of the shorter nylon cord out through the hole on the
side of the rim of the spool and then back into the
hole as illustrated. Pass the end of the other, longer
nylon cord out through the hole on the opposite side
of the spool as illustrated.
6.
Pass the end of each nylon cord out through the
eyelets on opposite sides of the housing. Place the
spool into the housing. Pull the end of nylon cords
while pressing down the spool.
7.
Adjust the length of nylon cords
so
that each nylon
cord extends approx. 80
mm
-
120
mm
(3-118"
-
4-314") out of the housing. If the nylon cord extends
out too much or does not extend out enough, adjust
the length of nylon cord while raising the spool
slightly within the housing.
11)
80
mm
~
120
mm
(3-118'' ~
4-314")
12