Makita RBC310 Trimmer User Manual


 
HOW
TO
OPERATE
The nylon cord will feed out automatically to a pre-determined length when you decrease and increase the engine
speed of your string trimmer. You do not need to tap the nylon cutting head to let the nylon cord feed out.
If the nylon cord does not feed out automatically, decrease the engine speed fully and then increase
it
fully.
The nylon cord will feed out automatically. If the nylon cord still does not feed out sufficiently, perform the
same procedures repeatedly until the nylon cord feeds out to the proper length. If the nylon cord is too short
to feed out automatically by performing the above procedures, stop the engine and pull out the nylon cord by
hand or using pliers more than
40
mm
(1-9116").
Then perform the above procedures again.
Increase
speed
Increase
speed
Decrease
speed
Lowest
speed
Full
speed
Lowest
speed
Full
speed
CAUTION:
NEVER OPERATE THE ENGINE AT HIGH RPM WITHOUT LOAD. With throttle fully opened and no load, the engine
rpm will be very high which can have an adverse effect on the life
of
the engine.
10