Filter
Top Products
8
ENGLISHFRANÇAISEESPAÑOL
Make sure that the appliance is switched OFF before connecting it to the generator.
Do not move the generator while it is running.
Be sure to ground the generator if the connected appliance is grounded. Failure to
ground unit may lead to electrical shock.
WARNING
2. USING ELECTRIC POWER
CONTROL PANEL
G1700I (60Hz-120V)
1 52 3 4
6
9
7
1011
8
(e)
After 20 to 30 seconds of warm-up is completed, turn the engine switch to " " (RUN) position. (See Fig. 4-e)
(f) Make sure the pilot lamp is on. This indicates that the generator is properly operating.
NOTE
Please consult with the Makita factory or authorized service center if the pilot lamp is turned off
during the proper operation.
(1) AC APPLICATION (See Fig.
44
-
rr
)
(a) Make sure the pilot lamp is turned on.
(b) Turn off the switch(es) of the electrical appliance(s) before connecting to the generator.
(c) Insert the plug(s) of the electrical appliance(s) into the receptacle. (See Fig. 4-r)
Check the amperage of the receptacles
used referring to TABLE 1, and be
sure not to take a current exceeding
the specified amperage.
Be sure that the total wattage of all
appliances dose not exceed the rated
output of the generator.
q PILOT LAMP
w OVERLOAD LAMP
e OIL SENSOR LAMP
r AUTO POWER SAVE LAMP
t AUTO POWER SAVE SWITCH
y AC RECEPTACLES
u AC CIRCUIT BREAKER
i DC TERMINALS
o DC CIRCUIT BREAKER
!0 GROUND TERMINAL
!1 ENGINE SWITCH
Up to 20A
Style Ampere
NEMA
5-20R
Duplex
Receptacle
Receptacle
NEMA
5-20P
AC plug
Description
TABLE 1