Filter
Top Products
8.
PREPARATION FOR STORAGE
-
Remove fuel strainer cup, open fuel cock and completely drain fuel from tank.
-After draining fuel, reinstall strainer cup and close the fuel cock.
-Start and run the generator without an appliance connected until the carburetor is
completely empty of fuel.
-
Change old lubricating oil with fresh oil.
-
Clean air cleaner element.
-
Remove spark plug and pour
5-10
cc
(1
fl.oz.)
of
lubricating oil through the plug hole.
Then pull starter handle several times and reinstall the spark plug.
-
Check for loose bolts and nuts. Retighten
if
necessary.
-
Clean generator throughly and spray completely with a preservative spray if available.
-
Be sure to place engine switch at the
"STOP"
position.
-
Pull
starter handle until resistance is felt and leave it in that position.
-
Storage indoors in a well-ventilated, low humidity area is recommended.
CAUTION]
Extreme care must be taken when draining fuel tank. Never use water to clean the
generator.
-
17
-