Filter
Top Products
17
Technical data DCS 330 TH
Single-cylinder two-stroke
Piston displacement 1.96 cu. in (32.3 cm
3
)
Cylinder bore 1.45" (37 mm)
Piston stroke 1.18" (30 mm)
Max. power at speed 1.0 / 7,000 kW/rpm
Max. torque at speed 1.45 / 5,800 Nm/rpm
Idling speed / max. engine speed with bar and chain 2,800 rpm / 11,000 rpm
Sound Pressure Level at the operator’s ear
at full load according to ANSI B 175.1 100 db(A)
Sound Pressure Level at the bystander’s position
(50ft/15 m distance) according to ANSI B 175.1 76 db(A)
Ignition system
Electronic, without breaker
Spark plug CHAMPION RCJ 8
or Spark plug
NGK BMR 6A
Electrode gap .020" (0.5 mm)
Fuel system
Carburetor WALBRO WT with limiter caps
(all position diaphragm carburetor
with integral fuel pump)
Fuel tank capacity 8.8 oz. (0.25 l)
Fuel mixture see chapter "Fuel"
Weight
without cutting attachment 7 lbs. 15 oz. (3.6 kg)
Cutting attachment
Guide bar sprocket nose bar
Cutting length 14" (35 cm)
Safety saw chain (pitch) 3/8
Drive link gauge .050
Chain sprocket 6 teeth
Chain lubrication fully automatic oil pump (variable-flow)
Oil tank capacity 5.6 oz. (0.16 l)
WARNING
Do not use other replacement bars and chains
unless they have been designated as meeting the
ANSI B 175.1-1991 (for USA) and CSA Z62.3-96
(for Canada) kickback performance requirements
on that specific powerhead, or has been desig-
nated as "low kickback" saw chain in accordance
with the ANSI B 175.1-1991 (for USA) and CSA
Z62.3-96 (for Canada) standard.
Approved bar and chain combinations
"Low-kickback saw chain is a chain which has met the
kickback performance requirements of ANSI B 175.1-
1991 (American National Standard for Power Tools-
Gasoline-Powered Chain Saws-Safety Requirements)
when tested on the representative sample of chain
saws below 3.8. C.l.D. specifed in ANSI B 175.1-
1991". The approved bar and chain combinations are
low kickback chains according to ANSI B 175.1-1991
and also meet the kickback requirements of CSA
Z62.3-96 for chain saws below 80 cm
3
.
The chain saw DCS 330 TH has been approved
with following guide bar and chain combinations:
Drive link gauge .050"
MAKITA: Guide bar 3/8" Saw chain 3/8"
length Part no. Part no.
14" (35 cm) 1682473 91VG-52E
OREGON: Guide bar 3/8" Saw chain 3/8"
length Part no. Part no.
14" (35 cm) 140SDEA041 91VG-52E
"There may be other replacement bar and chain combi-
nations available that also reduces the risk of injury
from kickback".