Makita 3703 Trimmer User Manual


 
Circular
work
0
Circular work may be accomplished if you assemble the straight guide and guide plate
0
Min. and max. radius
of
circles to be cut (distance between the center
of
circle and the
as
shown in
the
figure below.
center of bit) are
as
follows
:
Min.
:
70 mm (2-3/4")
Max.
:
221 mm (8-1 1/16")
(Note)
Circles between 172 mm (6-3/4") and 186 mm (7-5/16") in radius cannot
be
cut using
this guide.
A
Flat washer
Center hole
Guide plate
Straight guide
Bolt
Wing nut
Wave washer
Center hole
For cutting circles between 70 mm (2-3/4")
and 121 mm (4-3/4") in radius.
For cutting circles between 121" (4-3/4")
and 221 mm (8-1 1/16") in radius.
Align the center hole in the straight guide
with the center of the circle to be cut.
Drive
a
nail
less
than
6
mm (1/4") in
diameter into the center hole to secure the
straight guide. Pivot the tool around the
nail in clockwise direction.
8