Filter
Top Products
Installing
or
removing trimmer bit
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before installing or removing
the bit.
Insert the bit all the way into the collet
cone and tighten the collet nur securely
with the
two
wrenches.
To remove the bit, follow the installation
procedure in reverse.
CAUTION
:
0
Do
not tighten the collet nut without inserting
a
bit,
or
the collet cone will break.
0
Use only the wrenches provided with the tool.
Adjusting bit protrusion
To adjust the bit protrusion, loosen the nut
and move the tool
base
up or down
as
de-
sired by turning the adjusting screw. After
adjusting, tighten the nut firmly to secure
the tool base.
Switch action
To start the tool, move the switch lever
to
the
"ON"
position. To stop, move the
switch lever to the
"OFF"
position.
5