Filter
Top Products
7
Section 1: Assembly and Set-Up
7/16/07
ZR44 & ZR52 (S/N 472619 and below) Zero Turning Radius Mowers Riding Mowers 356-059M
Land Pride
Table of Contents
Section 1: Assembly and Set-Up
Control Lever & Seat Assembly
Refer to Figure 1-1:
The seat (#5) is shipped loose for ease in shipping and the
control lever’s upper bolts (#3) nuts (#2) and flat washers
(#4) are removed and the levers are rotated down.
2. Mount the standard seat, in the operating position, to
the seat platform with the four 5/16” x 3/4” bolts (#1)
and four 5/16” flat washers (the platform is slotted so
the seat can be adjusted to the operator). Connect the
switch wires on the mower with the switch wires on the
seat.
3. Mount the deluxe seat (optional), in the operating
position, to the seat platform with the four 5/16” nuts
and four 5/16” flat washers (the platform is slotted so
the seat can be adjusted to the operator). Connect the
switch wires on the mower with the switch wires on the
seat.
4. Rotate the control levers up until the holes line up and
replace the bolts and flat washers as shown.
Control Lever & Seat Assembly
Figure 1-1
20683