Filter
Top Products
9
Section 2: Operating
7/16/07
ZR44 & ZR52 (S/N 472619 and below) Zero Turning Radius Mowers Riding Mowers 356-059M
Land Pride
Table of Contents
Left/Right Fuel Tank Valve
Refer to Figure 2-3:
The mower is equipped with a Left/Right Fuel Tank Valve
that will determine which fuel tank the mower is operating
from. It is not important which fuel tank the mower is using.
Blade Engagement Switch
Refer to Figure 2-2:
The Blade engagement switch engages the deck blades.
Pull the switch up to engage and push switch down to
disengage the blades.
Control Levers
Refer to Figure 2-4
The Parking Brakes are applied by moving the control
levers from the Neutral Position (Figure 2-5) to an outward
position (Refer to Figure 2-4). Each rear wheel brake
operates independently of the other.
!
WARNING!
In the event of a system failure while mowing, engage both
parking brakes to stop or slow mower. Refer to Figure 2-4.
Refer to Figure 2-5:
These levers control the mower’s speed, direction, neutral
lock and park brake. Levers are used to steer, accelerate,
brake and change direction. The mower will not move
when engine is on, drive pumps are operating and control
levers are in park brake position (out).
!
WARNING!
The parking brake is not designed to hold the mower on steep
slopes.
Deck Lift Pedal
Refer to Figure 2-6:
The deck lift pedal is used to raise or lower the deck. Push
on the pedal to raise the deck and then place the deck
height locking pin into the desired cutting height hole.
Push the deck lift pedal to raise the deck when going over
obstructions.
Left/Right Fuel Tank Switch
Figure 2-3
IMPORTANT: Never engage blades with engine
running at high rpm or when the deck is under load.
Clutch, belts or deck could be damaged.
Control Levers in Parking Brake Position
Figure 2-4
20672
Control Levers
Control Levers
Figure 2-5
20667
Control Levers
Deck Lift
Pedal
Deck Lift Pedal
Figure 2-6
20670
Deck Height
Locking Pin