Filter
Top Products
11
8/12/14
RTR12 & RTA12 Series (Serial No. 884764-) Rotary Tillers 311-785M
Land Pride
Section 1: Assembly and Set-Up
Table of Contents
RTR 3-Point Hitch Assembly
Refer to Figure 1-3:
1. Install upper right-hand hitch plate (#4) to gearbox
mounting frame with 5/8"-11 x 1 3/4" GR5 cap
screw (#6), lockwashers (#14), and hex nuts (#9). Do
not tighten hardware at this time.
2. Repeat step 1 above to Install upper left-hand hitch
plate (#3) to gearbox mounting frame.
3. Install 1 1/4
" OD spacer (#1) between upper 3-Point
hitch plates (#4 & #5) with 3/4
"-10 x 4" GR5 cap
screw (#7), lockwasher (#15) and hex nut (#10).
4. Tighten all hex nuts (#9 & #10) to the correct torque.
5. Attach manual storage tube (#18) to hitch plate (#3)
with 1/4
"-20 x 1 1/4" GR5 cap screws (#8), flat
washers (#13) and nylock hex nuts (#12) as shown.
Tighten nuts to the correct torque.
6. Attach left-hand clevis (#5) to the square tube with
1/2" u-bolt (#17) and 1/2" hex lock nuts (#11). Do
Not Tighten lock nuts.
7. Repeat step 6 above for the right-hand clevis.
Refer to Figure 1-4:
8. Position clevises 26 7/8
" apart from inside of clevis
plate to inside of clevis plate and centered off the
gearbox input shaft 13 7/16
" as shown.
Refer to Figure 1-3:
9. Tighten u-bolt locknuts (#11) to the correct torque.
10. Skip to “Tractor Hook-Up” instructions on page 13.
Clevis Location (RTR Series Shown)
Figure 1-4
30349A
26 7/8"
13 7/16"
RTR 3-Point Hitch & Driveline Assembly
Figure 1-3
30347A