Filter
Top Products
32
Section 5: Hydraulic Plumbing
RCP2660, RCPM2660, RCP3060 and RCPM3060 Parallel Arm Rotary Cutter 316-111M
12/16/08
Land Pride
Table of Contents
Hydraulic Plumbing Without Solenoid
Refer to Figure 5-1:
The standard Parallel Arm Cutter is equipped with three
(3) remote cylinders to operate the parallel arms and
deck. These cylinders are connected directly to the
tractor's remote duplex outlets and are controlled by
tractor operator. Each cylinder requires a duplex outlet at
the tractor.
Hydraulic Plumbing With Solenoid
Refer to Figure 2-1 on page 25
and Figure 5-2 on this page.
The solenoid controlled cylinders provide for momentary
push button switch operation of each cylinder. These
cylinders are connected directly to the solenoid control
box. Two hydraulic hoses are connected directly to one
of the tractor’s remote duplex outlets. The hydraulic
cylinders are then controlled by an electrical control stick
with push button switches on the tractor near the
operator.
IMPORTANT: The flow control valve must be
plumbed correctly. See “Tractors Rated at 15 GPM
and Under” on page 16 and “Tractors Rated at 16
GPM and Above” on page 16.
Section 5: Hydraulic Plumbing
Remote Cylinder Plumbing without Solenoid Control box
Figure 5-1
22034
Remote Plumbing with Solenoid Control box
Figure 5-2
22035
The flow control valve must be plumbed correctly.
See “Tractors Rated at 15 GPM and Under” on page 16
and “Tractors Rated at 16 GPM and Above” on page 16.
Flow
Control
Valve
Solenoid
Control Box