Filter
Top Products
10
Introduction
RCP2660, RCPM2660, RCP3060 and RCPM3060 Parallel Arm Rotary Cutter 316-111M
12/16/08
Land Pride
Table of Contents
Terminology
“Right” or “Left” as used in this manual is determined by
facing the direction the machine will operate while in use
unless otherwise stated.
Definitions
Owner Assistance
The Warranty Registration card should be filled out by
the dealer at the time of purchase. This information is
necessary to provide you with quality customer service.
If customer service or repair parts are required contact a
Land Pride dealer. A dealer has trained personnel, repair
parts and equipment needed to service the cutter.
The parts on your cutter have been specially designed
and should only be replaced with genuine Land Pride
parts. Therefore, should your cutter require replacement
parts go to your Land Pride Dealer.
Serial Number Plate
For prompt service always use the serial number and
model number when ordering parts from your Land Pride
dealer. Be sure to include your serial and model numbers
in correspondence also. Refer to Figure 1: for the
location of your serial number plate.
Serial Number Plate Location
Figure 1
NOTE: A special point of information that the
operator must be aware of before continuing.
IMPORTANT: A special point of information related
to its preceding topic. Land Pride’s intention is that
this information should be read and noted before
continuing.
26964
Introduction
Land Pride welcomes you to the growing family of new
product owners.
This Rotary Cutter has been designed with care and built
by skilled workers using quality materials. Proper
assembly, maintenance and safe operating practices will
help you get years of satisfactory use from the machine.
Application
The Hydraulic Parallel Arm Rotary Cutters are designed
and built by Land Pride to provide excellent cutting
performance on ditch banks and other sloping areas
adjacent to right-of-ways, lakes, ponds and streams.
They are designed to work equally as well in and around
areas of restricted access such as over or under fences,
guardrails, low overhanging branches, tree limbs and
hedges. These units perform extremely well in tall grass
cutting applications and will easily cut through standing
brush up to two inches in diameter. An optional cutter
head equipped with two forward and one rear gauge
wheel is also available for customers who want to
maintain a constant cutting height with minimal control
lever manipulation.
The RCP2660 and RCPM2660 cutters are adapted for
Category 2 or 3 three-point hitch mounting on 75 hp. to
150 hp. tractors weighing 8,000 lbs. or more.
The RCP3060 and RCPM3060 cutters are adapted for
Category 2 or 3 three-point hitch mounting on 95 hp. to
175 hp. tractors weighing 12,000 lbs. or more.
The Hydraulic drive requires 540 rpm input PTO speed
for RCP2660 & RCP3060 models and 1000 rpm for
RCPM2660 & RCPM3060 models. Depending upon
hydraulic configuration, two or four duplex hydraulic
outlets are required on the tractor to operate the cutter’s
parallel arms and deck angle.
See “Section 7: Specifications & Capacities” on page
43 and “Section 8: Features & Benefits” on page 45 for
additional information and performance enhancing
options.
Using This Manual
•
This Operator’s Manual is designed to help familiarize
you with safety, assembly, operation, adjustments,
troubleshooting, and maintenance. Read this manual
and follow the recommendations to help ensure safe
and efficient operation.
• The information contained within this manual was
current at the time of printing. Some parts may change
slightly to assure you of the best performance.
• To order a new Operator’s or Parts Manual contact your
authorized dealer. Manuals can also be downloaded,
free-of-charge from our website at www.landpride.com.