Land Pride RC35120 RCM35120 Brush Cutter User Manual


 
Table of Contents
© Copyright 2000 All rights Reserved
Land Pride providesthis publication“as is”withoutwarrantyof anykind, eitherexpressedor implied.While everyprecaution hasbeen takenin thepreparationof thismanual,
Land Pride assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the useof the information contained herein. Land
Pride reserves the right to revise and improve its products as it seesfit. This publication describes the state of this product at the timeof its publication, and may not reflect
the product in the future. The illustrations in this manual are not intended for safe and proper assembly or disassembly of equipment. The illustrations are intended for or-
dering parts only.
Land Pride is registered trademark.
All other brands and product names are trademarks or registered trademarks of their respective holders.
Printed in the United States of America.
Land Pride
Table of Contents
RC35120 RCM35120 Rotary Cutter 312-301M
11/16/00
Important Safety Information . . . . . . . . . . . . . . . . . 1
Safety Notations. . . . . . . . . . . . . . . . . . . . . . . . . . 1
Safety Rules. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Safety Labels . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Using This Manual . . . . . . . . . . . . . . . . . . . . . . . . 6
Terminology: . . . . . . . . . . . . . . . . . . . . . . . . . 6
Definitions:. . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Owner Assistance . . . . . . . . . . . . . . . . . . . . . . . . 6
Section 1 Assembly and Setup . . . . . . . . . . . . . . . . 7
Tractor Requirements. . . . . . . . . . . . . . . . . . . . . . 7
Lift-Type Cutter. . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Hitch & Axle Assembly . . . . . . . . . . . . . . . . . 7
Tailwheel . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Pull-Type Cutter . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Tongue. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Rear Axle. . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Leveling Rod . . . . . . . . . . . . . . . . . . . . . . . . 10
Driveline Installation. . . . . . . . . . . . . . . . . . . . . . 11
Lift-Type Cutter . . . . . . . . . . . . . . . . . . . . . . 11
Pull-Type Cutter . . . . . . . . . . . . . . . . . . . . . . 11
Safety Guards . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Tractor Hook-Up. . . . . . . . . . . . . . . . . . . . . . . . . 11
Lift-Type Cutter . . . . . . . . . . . . . . . . . . . . . . 11
Pull-Type Cutter . . . . . . . . . . . . . . . . . . . . . . 13
Section 2 Operating Instructions . . . . . . . . . . . . . 14
Transporting . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Operating Check List . . . . . . . . . . . . . . . . . . . . . 14
Cutting Instructions . . . . . . . . . . . . . . . . . . . . . . 14
Section 3 Adjustments . . . . . . . . . . . . . . . . . . . . . . 16
Lift-Type Cutting Height. . . . . . . . . . . . . . . . . . . .16
Pull-Type Cutting Height . . . . . . . . . . . . . . . . . . .16
Deck Attitude Adjustment . . . . . . . . . . . . . . . . . . 16
Section 4 Troubleshooting . . . . . . . . . . . . . . . . . . .17
Section 5 Maintenance and Lubrication . . . . . . . . 19
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
Service Cutting Blades . . . . . . . . . . . . . . . . . . . .19
Skid Shoe Service & Replacement. . . . . . . . . . .19
Flex Couplers . . . . . . . . . . . . . . . . . . . . . . . . . . .20
Clutch Run-In . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Storage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Lubrication . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Pivoting Upper Hitch . . . . . . . . . . . . . . . . . . . . . .20
Lift-Type Tailwheel Spindle Hub . . . . . . . . . . . . .20
Lift-Type Tailwheel Hub . . . . . . . . . . . . . . . . . . . .21
Pull-Type Tailwheel Hub . . . . . . . . . . . . . . . . . . .21
Ratchet Jack . . . . . . . . . . . . . . . . . . . . . . . . . . . .21
Driveline U-Joints . . . . . . . . . . . . . . . . . . . . . . . .21
Driveline . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
Gearbox . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .22
T-Box. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
4-Plate Slip Clutch . . . . . . . . . . . . . . . . . . . . . . .23
Disassembly . . . . . . . . . . . . . . . . . . . . . . . . . 23
Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . .23
Section 6 Specifications and Capacities. . . . . . . . 24
Section 7 Appendix . . . . . . . . . . . . . . . . . . . . . . . . .25
Torque Values Chart for Common Bolt Sizes . . . 25