Filter
Top Products
3
3/20/07
Manual No. 700-520M
Assembly Instructions
Land Pride
■
Removal of Pulleys & Inner Enclosure
The following removed components will not be reused in
assembly of the new CVT drive.
Refer to Figure 3:
1. Remove 3/8" x 3 1/2" hex bolt (#7), lock washer (#9)
and CVT adapter (#17) from CVT drive pulley (#15).
2. Remove 1/2" x 2" hex bolt (#5), lock washer (#10)
and flat washer (#11) from CVT driven pulley (#16).
IMPORTANT: Pulley flanges will bend and nick easily
if handled roughly. Always handle pulleys gently to
prevent damage.
3. Remove CVT pulleys (#15 & #16) and CVT belt
(#14).
4. Remove CVT spacer (#1), shims (#19) and
3/16" x 1/4" x 2 1/2" key (#3) from engine drive shaft.
5. Remove 3/16" sq. x 3" long key (#2) from trans-axle
driven shaft.
6. Remove 5/16" x 3/4" hex socket screws (#4),
5/16" x 1" hex head bolts (#6), neoprene plated
washers (#12) and flanged lock nuts (#8).
7. Remove inner enclosure (#18) and gasket (#13).
Pulley and belt Removal
Figure 3