Filter
Top Products
9
Section 1: Assembly & Set-up
2/23/09
Model SBR48, SBR60 & SBR72 Seed Bed Roller 322-215M
Land Pride
Table of Contents
Roller Scraper Assembly
Figure 1-4
3-Point Hook-Up
Refer to Figure 1-5 & Figure 1-6:
!
DANGER
Crushing Hazard between tractor and implement. Do not
allow anyone to stand between tractor and implement while
backing-up to an implement. Do not operate hydraulic 3-point
lift controls while someone is directly behind the tractor or
near the Seed Bed Roller.
!
DANGER
Engage parking brake, shut off tractor and remove key before
dismounting from the tractor.
!
WARNING
See Figure 3-5 on page 15. Chock front and back of roller
when using support stand to prevent unit from rolling and
causing property damage and/or bodily injury.
A 3-Point Category I hitch is required. The lower 3-Point
arms of the 3-Point hitch must be stabilized to prevent
side-to-side movement. Most tractors have sway blocks
or adjustable chains for this purpose.
1. Slowly back tractor up to the Seed Bed Roller while
using the tractor’s 3-point hydraulic control to align
the lower lift arm hitch holes with the clevis lug holes
on the Seed Bed Roller.
2. Engage tractor park brake, shut tractor engine off
and remove key before dismounting from tractor.
3. With lower lift arm hitch holes aligned with clevis lug
holes, insert hitch pins (#1) through clevis and lower
arm holes. Secure hitch pins with linchpins (#6).
4. Align top center link hitch hole with the upper hitch
holes and insert 3/4" bolt (#4). Secure bolt with
flange lock nut (#5). Draw nut up snug.
5. Ensure lower hitch arms are blocked to prevent
excessive side movement.
2576
4
6. Return to the tractor, start engine and slowly operate
3-point controls to lift lower arms up just enough to
raise support stand (#3) off the ground.
7. Engage tractor park brake, shut tractor engine off
and remove key before dismounting from tractor.
8. Remove support stand (#3), turn it over and reattach
it as shown in Figure 1-6 with wire snap lock pin (#7).
(Remember: Small notches in stand are mounted
towards the frame tube.)
9. Operate 3-point controls up and down to check for
clearance between the Seed Bed Roller and tractor.
Move or remove tractor drawbar if it interferes with
the Seed Bed Roller.
10. Manually adjust one of the two Lower lift arms up or
down to level the Seed Bed Roller from left to right.
Manually adjust the length of the top center link to
level the Seed Bed Roller from front to rear.
11. When using a Quick Hitch, attach center hook to
1 1/4" spacer (#2) and lower hooks to hitch pins (#1).
Tractor 3-Point Hitch
Figure 1-5
Seed Bed Roller Hook-Up
Figure 1-6
23998
Top Center Link
Hitch Hole
Lower Lift Arm
Hitch Holes
PTO Shaft
25781
Lower Lift Arm Hole
Alignment Positions
Top Center Link Hole
Alignment Position