Filter
Top Products
21
12/24-HOUR FORMAT SETTING:
The hour display can be selected to show hours in 12-hour or 24-hour
settings. (Default 12-Hour)
1. Use the OUT/+ key to toggle between “12H” or “24H”.
2. Confirm with the SET key and enter the Manual time setting.
MANUAL TIME SETTING:
If Weather Station cannot detect the WWVB-signal due to disturbances,
transmission distance, etc., the time can be set manually. The clock will
then work as a normal Quartz clock.
Hour flashing
Minutes flashing
Flashing
22
1. The hour digit will start flashing.
2. Use the OUT/+ key to set the hour.
3. Press again the SET key to set the minutes. The minute digits start
flashing.
4. Use the OUT/+ key to set the minutes.
5. Confirm with the SET key and enter the Calendar setting.
Note: If the WWVB reception function is set to "ON", the unit will still try to
receive the WWVB time signal between midnight and 6:00 am every day,
even if the time was set manually. When it does receive the signal, it will
change the manually set time into the received time. During reception
attempts, the WWVB tower icon will flash. If reception has been
unsuccessful, then the WWVB tower icon will not appear but reception
will still be attempted the following hour.
CALENDAR SETTING:
Year
23
Note: When set to 24-hour time, the calendar setting mode will display
the date to the left of the month.
The date default of the Weather station is 1. 1. 2006. Once the radio-
controlled time signals are received, the date is automatically updated. If
the signals are not received, the date can also be set manually.
1. The year starts flashing.
2. Use the OUT/+ key to set the year (between year 2003-2029).
3. Press the SET key again to confirm and to enter the month setting.
The month starts flashing.
4. Use the OUT/+ key to set the month.
5. Press the SET key again to confirm and to enter the date setting
mode. The date starts flashing.
6. Use the OUT/+ key to set the date.
7. Confirm all calendar settings with the SET key and enter the
Temperature unit setting.
Month and date
(12hr time format)
Date and month
(24hr time format)
24
Note: The Day of the Week will set automatically when the year, month
and date are set.
°C/°F TEMPERATURE SETTING:
The temperature display can be selected to show temperature data in °C
or °F (Default °F).
1. Use the OUT/+ key to toggle between “°C” or “°F”.
2. Confirm with the SET key and enter the Air pressure unit setting.
AIR PRESSURE UNIT SETTING (hPa / inHg):
The pressure display can be selected to show relative air pressure in hPa
or inHg (default is “inHg”).
1. Use the OUT/+ key to toggle between “hPa” or “inHg” unit
Flashing
Flashing