Filter
Top Products
Page| 13
The storm warning display (flashing downward weather tendency arrow) can be
accompanied by a ring of the alarm. Switch the acoustic storm warning alarm On
(AON) or Off (AOFF) (Default OFF).
1. The digit "AOFF" will flash.
2. Press the ▲/DATE button or ▼/RAIN button to switch the alarm On or Off.
("AOFF" = Off; "AON" = On)
3. Press the SET button to confirm and to enter the WIND DIRECTION DISPLAY
TYPE.
WIND DIRECTION DISPLAY TYPE
The wind direction can be displayed using either compass directions or degree measurements. N is
equivalent to 0° on the compass. The default setting is compass directions.
1. The wind direction will flash.
2. Press the ▲/DATE button or ▼/RAIN button to toggle from compass
directions to degree measurements.
3. The next steps in SET mode is the factory reset, so unless you wish to
reset the display to factory defaults, simply wait until the SET mode times
out and returns to the Mode 1 display.
4. If you wish to perform a FACTORY RESET, press the SET button to confirm and to enter the
FACTORY RESET PROCEDURE. SEE WARNINGS in the FACTORY RESET section.
FACTORY RESET PROCEDURES
WARNING: Internet Connection Reset Only
The factory reset procedure has an option to clear the remote monitoring registration information only
from the weather station.
1. "rES oFF" will flash.
2. Use the ▲/DATE button or ▼/RAIN button to select "rES Lo".
3. Press the SET button to confirm and the weather station will return to the normal weather display
mode.
4. Follow the instructions at www.lacrossealerts.com
to reregister the weather station online.
WARNING: Avoid Factory Reset
Performing a factory reset will erase all MIN/MAX values and weather data stored in the display's internal
memory and return the weather station’s settings back to the factory defaults.
If you do not wish to reset the display to factory defaults, either:
• Press the MIN/MAX button or the ALARM button to exit SET mode, or
• Simply wait 30 seconds until the SET mode times out and returns to the Mode 1 display.
WARNING: Complete Factory Reset
A factory reset will erase the Internet connection and the connection between the display and the
thermo-hygro sensor and require the all sensor connections to be re-established.
5. "rES oFF" will flash.
6. Use the ▲/DATE button or ▼/RAIN button to select "rES ALL".
7. Press the SET button to confirm and a countdown timer will begin counting down from "127"
When the timer displays "dOnE", you must remove the batteries from the display for 10 minutes.
While the batteries are out of the display, also remove the batteries from the thermo-hygro sensor
and rain sensor.