Filter
Top Products
Support the weight of the column. Connect
the water pipe to the connector from
at the top of the column.
Caution
Support the weight of the column. Plug the
electrical cable into the connector on the cable
from the Water Delivery System
Caution
12
17
CFI230G
Check the lintel is level.
If adjustment is required turn screw ‘A’
on the panel clamps to lift or lower the rail.
Note: If the lintel cannot be made level by
adjusting the clamps remove the grub screws
and fit the longer ones supplied in the parts pack.
When the lintel is level tighten screw ‘B’ on
each panel clamp until it grips the glass.
IMPORTANT - DO NOT OVER TIGHTEN
Fit caps to lintel ‘C’
A
B
Remove the lintel from glass and remove the parking block
1. Match parking block
to mark on wall
5. Screw parking block to wall
3. Drill holes with 6mm drill
4. Plug holes
6. Re-fit lintel to glass
and push wall mount
on to the parking block
7. Secure the lintel to
parking block by
tightening allen
screw ‘A’
A
A
2. Spot drill hole positions
STEP
43
STEP
42
Carefully lift the Water
Delivery System column
and place the bottom
into the jamb assembly
Be very careful not
to scratch or damage
the tray
Fixed Head Water Delivery Only
STEP
44
STEP
45
C
CFI230G
STEP
24
STEP
25
Push top of column
into jamb assembly
until it locks in place