Filter
Top Products
set-up button continuously for more than 2 seconds, the digital will change quickly. If you don’t press
the button in more than 5 seconds, the digital will stop flashing, set-up value will be memorized. This
value will be shown when you restart next time.
During sauna session, set-up time will count down the minutes one by one. When the left time is 5
minutes, the equipment will make a warning sound for 15 seconds, at this moment, time display is
flashing. During these 15 seconds, you can press any set-up button to stop warning sound, and
reset up the time of new sauna session. If you don’t set up the time again, after 15seconds, sauna
continues, when display time is 0, the equipment will power off automatically. Particularly the
equipment will also power off if you don’t press any bottom in 5 minutes after you power on the
sauna!
4. Switch between
0
F and
0
C
When power is on, “
0
C” and “
0
F” will switch when you press “
0
C/
0
F”. And the TEMPERATURE
DISPLAY value will change accordingly.
5. Set up the heating temperature
When you turn the power on, press TEMPERATURE button “▲” or “▼” to increase or decrease the
heating temperature of sauna room. The temperature will increase or decrease I minute when you
press one time. If you press the set-up button continuously for more than 2 seconds, the digital will
change quickly. This value will be the set-up sauna temperature. If you don’t press the button in
more than 5 seconds, the digital will stop flashing, set-up value will be memorized. It will show this
value when you restart the next time.
6. Start emitting or stop emitting
When powering the sauna on, press WORK START/STOP button one time, WORK and HEAT light
is on, the emitters will start emitting. (If you press this button again, emitters are off, WORK and
HEAT light is off.) In the summer (room temperature is around 30
0
C/86
0
F), (such as 2 person sauna)
heating time and actual inside temperature like the following datasheet:
actual inside temperature 40
0
C(104
0
F) 50
0
C(122
0
F) 55
0
C(131
0
F) 60
0
C(140
0
F) 66
0
C(150.8
0
F)
Heating time (minutes) 5~7 17~19 23~25 31~33 43~45
When environmental temperature is low, heating requires additional time. The above data is only for your
reference. When the temperature is at the set-up value, the digital control will maintain the set temperature.
The WORK light will remain on and the HEAT light will turn off. When the top heating, the sauna will maintain
the set-up temperature for some time, when the inside temperature drops 2
0
C, the digital control will make the
emitters continue heating until it reaches the set-up value. With the digital control, the inside sauna
temperature is always around the set-up value.
7. Inside reading lamp switch
1) Press the light ON/OFF button one time to switch on, press again to switch off.
8. MP3 socket: Connect your MP3 player or radio (not supplied) to the MP3 socket while taking a
sauna, the speakers will then work. (see figure 31)