Filter
Top Products
5
Connecting speakers to the FRONT SPEAKERS 1 terminals
For each speaker, connect the (+) and (–) terminals on the rear panel
to the (+) and (–) terminals marked on the speakers.
1
Cut, twist and remove the insulation at the end of
each speaker signal cable (not supplied).
2
Turn the knob counterclockwise.
3
Insert the speaker signal cable.
4
Turn the knob clockwise.
Connecting speakers to the FRONT SPEAKERS 2 terminals
For each speaker, connect the (+) and (–) terminals on the rear panel
to the (+) and (–) terminals marked on the speakers.
1
Cut, twist and remove the insulation at the end of
each speaker cord.
2
Open the terminal (1), then insert the speaker
cord (2).
3
Close the terminal.
Connection diagram
FRONT
SPEAKERS
RIGHT LEFT
+
1
–
RIGHT LEFT
2
+
–
FRONT
SPEAKERS
1
FRONT
SPEAKERS
2
RIGHT
LEFT
1
RIGHT
LEFT
1
1
2
3
1
2
4321
“NO” for the subwoofer, “LARGE” for the front speakers,
and “SMALL” for the center and rear speakers are initial
settings. To get best possible sound, change the subwoofer and
speaker settings to fit your listening conditions.
Connecting the Speakers
Speaker layout diagram
After connecting the front, center, rear speakers and/or subwoofer,
set the speaker setting information properly to obtain the best
possible Surround effects. For details, see pages 16 to 18.
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
Connecting the front speakers
You can connect two pairs of front speakers (one pair to the FRONT
SPEAKERS 1 terminals, and the other pair to the FRONT
SPEAKERS 2 terminals).
About the speaker impedance
The required speaker impedance of the front speakers does differ
depending on whether both the FRONT SPEAKERS 1 and FRONT
SPEAKERS 2 terminals are used or only one of them is used.
CASE 1 When you connect only one pair of front speakers
Front
speaker
1
Front
speaker
1
Use front speakers with 8 Ω – 16 Ω impedance.
CASE 2 When you connect two pairs of front speakers
Front
speaker
1
Front
speaker
2
Front
speaker
2
Front
speaker
1
Use front speakers with 16 Ω – 32 Ω impedance.
Right rear
speaker
Left front
speaker
Subwoofer
Center
speaker
Left rear
speaker
Right front
speaker
DVD VCR
TV SOUND/DBS
ADJUST
RX-7020VAUDIO/VIDEO CONTROL RECEIVER
SETTING
MASTER VOLUME
CONTROL
DOWNUP
CD
TAPE/CDR
SOURCE NAME
BASS BOOST
INPUT
ANALOG/DIGITAL
SPEAKERS ON/OFF
SURROUND MODE
PHONES
SURROUND ON/OFF
FM/AM TUNING
STANDBY
FM/AM PRESETFM MODE
MEMORY
INPUT ATT
FM/AM
DIGITAL
SURROUND
DVD MULTI
PHONO
SOURCE NAME
12
COMPULINK
Remote
Getting Started
RIGHT
LEFT
1
EN01-09.RX-7020V[A]3 02.4.17, 5:15 PM5